Magnetic Drive ConveyorMJD

Model example

MJD

30

D

L

100

F15

L

06

X

*Colored text is semi-standard.

	Model code		MJD (standard type)
	Nominal width		15	20	25	30	35	40	50	60
RW Actual roller width (mm)			119	169	219	269	319	369	469	569
FW Frame width (mm)			230	280	330	380	430	480	580	680
	L Captain (cm)		100、125、150
Carrier Roller Diameter			φ18
Roller pitch (mm)			25
Roller Material			stainless
	Drive Type		D: Subscript
	Drive shaft direction *1		R: Right side L: Left side
	Speed symbol		Please refer to the "Speed Symbol/Conveyor Speed Table"
	Controller installation direction *1		R: Right side L: Left side
	Motor Output	N: constant speed	06:60W
		F/G: Inverter gear change *2	06:60W
	Input Power		X: 100V single phase Y: 200V single phase Z: 200V three phase

1. Please refer to "Drive shaft direction/controller installation direction."
2. "F" indicates Mitsubishi products and "G" indicates Toshiba products.

• Do not use the unit when it is out of step.
• Do not use in dusty environments or in environments where water, oil, etc. may be present.
• Overhanging transport is not possible.
• If you are using a pacemaker or other medical device, please do not go near the magnet as it may affect your health.

• 1. Colored text indicates substandard speeds.
  2. The constant speed and inverter variable speed will fluctuate by approximately ±10% depending on the load.
  3. "F" indicates Mitsubishi products and "G" indicates Toshiba products.