Magnetic Drive ConveyorMFVS

Model example

MFVS

20

D

B

204.2

D15

R

09

X

*Colored text is semi-standard.

	Model code		MFVS (Centering type resin roller)
	Nominal width		20	30
RW Actual roller width (mm) *1			204 (102RW x 2)	304 (152RW x 2)
FW Frame width (mm)			380	480
	L Captain (cm)		104.2	144.2
Carrier Roller Diameter			φ18
Roller pitch (mm)			20
Roller material *2			MFVS: Black resin
	Drive Type		D: Subscript
	Drive shaft direction *3		B: Both sides
	Speed symbol		Please refer to the "Speed Symbol/Conveyor Speed Table"
	Controller installation direction *3		R: Right side L: Left side
	Motor Output	N: constant speed	02:25W 04:40W 06:60W 09:90W
		D：ブラシレス変速	05:50W 09:90W
		F：インバータ変速	02:25W 04:40W 06:60W 09:90W
Number of motors			2 units
	Input Power		X: 100V single phase Y: 200V single phase Z: 200V three phase

1. Please check the standard drawing for the effective width.
2. White resin rollers are also available (optional).
3. Please refer to "Drive shaft direction/controller installation direction."

• Do not use the unit when it is out of step.
• Do not use in dusty environments or in environments where water, oil, etc. may be present.
• Overhanging transport is not possible.
• If you are using a pacemaker or other medical device, please do not go near the magnet as it may affect your health.

Note) Please see here for the frame cross section.

Note: The above capacity varies depending on the type of transported item and the condition of the bottom surface.

• 1. 色文字 は準標準速度を表します。
  2. 定速とインバータ変速の速度は、負荷により±10%程度変動します。
  3. ブラシレス変速時の負荷による速度変動は±1%以内です。