Product Information

Magnetic Drive ConveyorMFQS

Skewed type (resin roller)

A skewed conveyor made of aluminum frame that shifts conveyed items from the center to one side

Magnetic Drive Conveyor / MFQS
About the various icons
Magnetic Drive Conveyor / MFQS

specification

Model example
MFQS 30 D LL 203.4 D15 L 09 X

*Colored text is semi-standard.

Model code MFQS (skewed type resin roller)
Nominal width 15 20 25 30 35 40 50 60
RW Actual roller width (mm) 132 182 232 282 332 382 482 582
FW Frame width (mm) 230 280 330 380 430 480 580 680
L Captain (cm) *1 MIN. 61.8 62.3 62.8 63.4 63.9 64.4 65.5 66.5
MAX. 301.8 302.3 302.8 303.4 303.9 304.4 305.5 306.5
Carrier Roller Diameter φ18
Roller pitch (mm) 20
Roller material *2 MFQS: Black resin
Drive Type D: Subscript
drive shaft
direction *3
Right shaft RR: Right side RL: Left side
Left shaft LR: Right side LL: Left side
Speed symbol See the speed chart
Controller installation direction *3 R: Right side L: Left side
Motor Output N: constant speed 02:25W 04:40W 06:60W 09:90W
D:ブラシレス変速 05:50W 09:90W
F:インバータ変速 02:25W 04:40W 06:60W 09:90W
Input Power X: 100V single phase Y: 200V single phase Z: 200V three phase
  1. The length is measured in 20cm increments.
  2. White resin rollers are also available (optional).
  3. Please refer to "Drive shaft direction/controller installation direction."
  • Do not use the unit when it is out of step.
  • Do not use in dusty environments or in environments where water, oil, etc. may be present.
  • Overhanging transport is not possible.
  • If you are using a pacemaker or other medical device, please do not go near the magnet as it may affect your health.
  • This applies to loads of 300g or more. This may vary depending on the size, shape, and other conditions of the load, so please contact our sales department for more information.

Dimensions

Note) Please see here for the frame cross section.

Size restrictions for each width of transported items


注)上記は参考値になります。ご検討の際は弊社営業部までお問い合わせください。
※ 機長により異なります。

Estimated payload


注)上記は樹脂ガイド(μ=0.08)を使用した場合の数値です。
 ガイド種類や搬送物により変化します。

Speed symbol/Conveyor speed table


  • 1. 色文字 は準標準速度を表します。
    2.定速とインバータ変速の速度は、負荷により±10%程度変動します。
    3.ブラシレス変速時の負荷による速度変動は±1%以内です。

Drive shaft direction/controller installation direction

none