Product Information

HOME > Product Information > Conveyor Equipment > Light Conveyor > Fine Conveyor > Fine Conveyor II Petacon 60 / FHQ

Fine Conveyor II Petacon 60FHQ: Standard Type
FHQG: Snake-less type

A thin belt conveyor with no protrusions on the bottom surface

Fine Conveyor II Petacon 60 / FHQ
About the various icons
Fine Conveyor II Petacon 60 / FHQ

specification

Model example
FHQ 30 P L 200 S12 D 04 AC power only switch selection

*Colored text is semi-standard.

Model code FHQ (head drive standard type) FHQG (head drive meander-less type)
Nominal width 30 40 50 60
BW Actual belt width (mm) 300 400 500 600
FW Frame width (mm) 380 480 580 680
Captain (cm) MIN 46 50 62.5 75
MAX 300
Drive Type P: Motor pulley
Standard Belt FHQ: Resin flat belt (1-ply) FHQG: Resin meandering prevention belt with bars (1-ply)
End Pulley Diameter φ38
Lead wire pull-out direction R: Right side of conveying direction L: Left side of conveying direction (standard) *Driver board mounting direction
Speed symbol S: Speed selection type *Please refer to the "Speed symbol/Conveyor speed table".
Motor Output DC brushless motor roller (04: 40W)
Input Power D: DC24V (X: AC100V single phase Y: AC200V single phase)
For AC power supply unit specifications
Select Switch		 S: CB type (start/stop only)
V: CBS type (with start/stop and speed setting switch)
Transport mass MAX.20kg/unit
  • - If the machine length is 550mm or more, a return roller will be attached.
    ・If the machine length is less than 750mm, the driver board will be installed separately.

Driver board specifications

  • Motor: DC24V, 0.3 to 3.4A (rated current)
    *The rated current varies depending on the speed.
  • Power supply capacity /DC24V 4A or more
  • Operating temperature: 0 to 40°C (no condensation)
  • Board size: length 116 x height 50 x depth 27 mm
  • Protection fuse / 8A
  • Temperature Protection /Thermal
  • Others /Slow start/Slow down function

If you are using it in an AC (alternating current) environment, an optional power supply unit (DC conversion) is available.
The power supply unit comes as a set of a switch and an AC adapter.

Dimensions

  • 1. When the driver board, switch (S:CB type), and AC adapter are installed on the same side of the conveyor frame, the shortest length is 1,200m. For other switches, please contact our sales department.
    2. The driver board is normally installed on the left side of the conveying direction..
    3. Frame cross section Here Please refer to.
    4. Driver board detailsHerePlease refer to.

Speed symbol/Conveyor speed table

  • 1. The above speeds can be selected using the DIP switch or an external signal. (It is not an infinitely variable speed.)
    2. Speed may vary depending on the load.
    3. When changing the speed using an external input voltage, please keep the upper speed limit at 29.3 m/min or less.
    4. When controlling the speed externally with 24V DC or when installing a switch (CBS type), set the speed symbol to "00".
none