Fine Conveyor IIFHG 200W (100W)

Model example

FHG

30

D

R

300

F16

R

20

Z

*Colored text is semi-standard.

	Model code		FHG (Head drive, meander-less)
	Nominal width *1		20	25	30	35	40	50	60	70	80	90	100
BW Actual belt width (mm)			200	250	300	350	400	500	600	700	800	900	1,000
FW Frame width (mm)			280	330	380	430	480	580	680	780	880	980	1,080
	Captain (cm)	MIN	70								80	90	100
		MAX	800 *High speed specification is 400							800		400
Standard Belt			Resin belt with anti-snake bars (2-ply) *High-speed specifications are 1-ply
End Pulley Diameter			φ38							φ57
	Drive unit type *2		D: Downward (standard) U: Upper-mounted H: Side-mounted (hollow shaft)
	Mounting direction of drive unit *2		R: Right side of conveying direction L: Left side of conveying direction
	速度記号		Please refer to the "Speed Symbol/Conveyor Speed Table."
	Controller installation direction *2		R：搬送方向右側　L：搬送方向左側　T：コントローラ無し※3
	Motor Output	N: constant speed	20：200W　10：100W 注）速度記号N06、F06、P06以下の時は100Wになります。
		F：インバータ変速
		P：IPM変速※4
	入力電源 ※5		X: 100V single phase Y: 200V single phase Z: 200V three phase
搬送質量※6			MAX. 120kg/unit

1. The applicable nominal width for high-speed specifications is 20 to 60.
2. Please check here for details.
3. T：コントローラ無しは、N：定速の入力電源Z：200V三相のみ適用します。
4. The speed change method is an inverter dedicated to IPM motors.
5. 単相電源にする場合は、F：インバータ変速のみ適用します。
6. The payload varies depending on the speed. Please refer to "Guideline for payload."

• We can also manufacture products other than the standard specifications, so please contact us for details.

Power supply compatibility table

Note) Please see here for the frame cross section.

Note: The graph/table below shows the transport mass when the load is distributed horizontally.

• 1. 色文字 は準標準速度を表します。
  2.「N06」 「F06」「P06」以下の場合、モータ出力は100Wになります。（ □ 部分）
  3. 定速とインバータ変速の速度は、負荷により±10%程度変動します。