Product Information

HOME > Product Information > Conveyor Equipment > Light Conveyor > Fine Conveyor > Fine Conveyor II / FBS 200W

Fine Conveyor IIFBS 200W (100W)

Powerful knife edge type

With a maximum width of 1,000mm, passengers can easily move between multiple rows.

Fine Conveyor II / FBS 200W
About the various icons
Fine Conveyor II / FBS 200W
Web Catalog

specification

Model example
FBSB 80 D R 200 F20 R 20 Z

*Colored text is semi-standard.

Model code FBSB (Center drive double knife edge)
FBSU (upstream only) FBSD (downstream only)
Nominal width 20 25 30 35 40 50 60 70 80 90 100
BW Actual belt width (mm) 190 240 290 340 390 490 590 690 790 890 990
FW Frame width (mm) 280 330 380 430 480 580 680 780 880 980 1,080
Captain (cm) MIN 90 100 120 140 160 180 200
MAX 400※1 400
Standard Belt Resin flat belt (1 ply)
Edge Radius R3
End pulley diameter *2 φ34 φ57
Drive unit type *3 D: Subscript
Mounting direction of drive unit *3 R: Right side of conveying direction L: Left side of conveying direction
速度記号 Please refer to the "Speed Symbol/Conveyor Speed Table."
Controller installation direction *3 R：搬送方向右側　L：搬送方向左側　T：コントローラ無し※4
Motor Output N: constant speed 20：200W　10：100W
注）速度記号N06、F06、P06以下の時は100Wになります。
F：インバータ変速
P：IPM変速※5
入力電源 ※6 X: 100V single phase Y: 200V single phase Z: 200V three phase
搬送質量※7 Double knife edge: MAX. 25 kg/unit Single knife edge: MAX. 40 kg/unit
  1. We can also manufacture units with lengths of 4 to 8 meters. However, performance may be reduced depending on the operating environment.
  2. Non-knife edge side of one-sided knife edge specification
  3. Please check here for details.
  4. T：コントローラ無しは、N：定速の入力電源Z：200V三相のみ適用します。
  5. The speed change method is an inverter dedicated to IPM motors.
  6. 単相電源にする場合は、F：インバータ変速のみ適用します。
  7. The payload varies depending on the speed. Please refer to "Guideline for payload."
  • We can also manufacture products other than the standard specifications, so please contact us for details.

Power supply compatibility table

Dimensions

Note) Please see here for the frame cross section.

Estimated payload

Note: The graph/table below shows the transport mass when the load is distributed horizontally.

Speed symbol/Conveyor speed table

  • 1. 色文字 は準標準速度を表します。
    2.「N06」「F06」「P06」以下の場合、モータ出力は100Wになります。（ ■ 部分）
    3. 定速とインバータ変速の速度は、負荷により±10%程度変動します。
    4.「N25」「F25」「P25」以上の場合、搬送能力は低下します。（ ■ 部分）
none