Fine Conveyor IIFBR 200W (100W)

Model example

FBRB

30

D

R

300

F16

R

20

Z

*Colored text is semi-standard.

	Model code		FBRB (center drive, double roller edge) FBRU (upstream only) FBRD (downstream only)
	Nominal width *1		20	25	30	35	40	50	60	70	80	90	100
BW Actual belt width (mm)			200	250	300	350	400	500	600	700	800	900	1,000
FW Frame width (mm)			280	330	380	430	480	580	680	780	880	980	1,080
	Captain (cm)	MIN	60			70	80	100	120	140	160	180	200
		MAX	400
Standard Belt		Medium/low speed	Resin belt with one row of anti-snake bars (2-ply)							Belt with two rows of anti-snake bars (2-ply)
		high speed	Resin belt with one row of anti-snake bars (1 ply)							-
Edge Radius			φ16 (R8)
End pulley diameter *2			φ38							φ57
	Drive unit type *3		D: Subscript
	Mounting direction of drive unit *3		R: Right side of conveying direction L: Left side of conveying direction
	速度記号		Please refer to the "Speed Symbol/Conveyor Speed Table."
	Controller installation direction *3		R：搬送方向右側　L：搬送方向左側　T：コントローラ無し※4
	Motor Output	N: constant speed	20：200W　10：100W 注）速度記号N06、F06、P06以下の時は100Wになります。
		F：インバータ変速
		P：IPM変速※5
	入力電源 ※6		X: 100V single phase Y: 200V single phase Z: 200V three phase
搬送質量※7			MAX. 60kg/unit

1. The applicable nominal width for high-speed specifications is 20 to 60.
2. Non-roller edge side of single-side roller edge specification
3. Please check here for details.
4. T：コントローラ無しは、N：定速の入力電源Z：200V三相のみ適用します。
5. The speed change method is an inverter dedicated to IPM motors.
6. 単相電源にする場合は、F：インバータ変速のみ適用します。
7. The payload varies depending on the speed. Please refer to "Guideline for payload."

• We can also manufacture products other than the standard specifications, so please contact us for details.

Power supply compatibility table

Note) Please see here for the frame cross section.

Note: The graph/table below shows the transport mass when the load is distributed horizontally.

• 1. 色文字 は準標準速度を表します。
  2.「N06」 「F06」「P06」以下の場合、モータ出力は100Wになります。（ ■ 部分）
  3. 定速とインバータ変速の速度は、負荷により±10%程度変動します。