Belcon Mini Slim MiniMQB

Model example

MQB

50

R

120

S10

D

*Colored text is semi-standard.

	Model code	MQB (head drive round belt)
	Nominal width	50
BW Actual belt width (mm)		50
FW Frame width (mm)		60
	Captain (cm)	MIN.50〜MAX.150
Standard Belt		Resin round belt
End Pulley Diameter		φ57
	Mounting direction of drive unit	R: Right side of conveying direction (standard) L: Left side of conveying direction 　 *Driver board mounting direction
	Speed symbol	S: 06, 10, 15 Please refer to the "Speed Symbol/Conveyor Speed Table" *Speed selection type
Motor Output		DC brushless motor (61W)
	Input Power	D: DC24V (X: AC100V single phase Y: AC200V single phase Z: AC200V three phase)
Transfer mass *1		MAX.5kg/unit

1. Conveying capacity varies depending on speed. Please refer to "Conveying capacity guideline."

Driver board specifications

• Motor: DC24V, 2.55A (rated current)
• Power supply capacity /DC24V 3A or more
• Operating temperature: 0 to 40°C (no condensation)
• Board size: length 106 x height 41 x depth 21 mm
• others /Start/stop acceleration/deceleration time setting function, forward/reverse rotation function, and three speed selections possible from an external signal
  (There are some restrictions on selection, so please refer to the "Speed Symbol/Conveyor Speed Table.")

• If you are using it in an AC (alternating current) environment, an optional power supply box (DC conversion box) is available.

1. When the power supply box is attached to the conveyor body, it protrudes 60.5 mm in the width direction of the frame. Power supply box dimensions: length 164 x height 40 x depth 60.5 mm
2. If the input power supply is three phases, one phase is left out at the input.

• 1. Please refer here for the frame cross section and motor protrusion dimensions (dimensions A, B, and C in the diagram above).
  2. For details on the driver board, please see here.

• 1. Change the speed setting using the driver's DIP switch. (You can select a setting speed within the speed symbol range.)
  2. Furthermore, speed control of 100%, 75%, or 50% of the set speed is possible using an external input signal. (The external speed control range differs depending on the set speed, so please refer to the table above.)
  3. Speed may vary depending on the load.