Belcon Mini IIIDPH

Model example

DPH

30

D

R

150

D13

R

04

X

*Colored text is semi-standard.

	Model code		DPH (Center drive, removable belt, standard)
	Nominal width		20	25	30	35	40	50	60
BW Actual belt width *1 (mm)			197	247	297	347	397	497	597
FW Frame width (mm)			245	295	345	395	445	545	645
	Captain *2 (cm)		Nominal width 20 to 40: MIN.90 to MAX.1,200 Nominal width 50/60: Min. nominal width x 2 to Max. 1,200
Machine height (mm)			640≦Machine height H≦1,040
Standard Belt			Resin flat belt (1 ply)
End Pulley Diameter			φ27.2
	Drive unit type *3		D: Subscript (parallel axis)
	Mounting direction of drive unit *3		R: Right side of conveying direction L: Left side of conveying direction
	Speed symbol		Please refer to the "Speed Symbol/Conveyor Speed Table"
	Controller installation direction *3		R：搬送方向右側　L：搬送方向左側　T：コントローラ無し※4
	Motor output *5	N: constant speed	02:25W 04:40W 06:60W 09:90W
		D：ブラシレス変速	04：40W　09：90W
		F：インバータ変速	02:25W 04:40W 06:60W 09:90W
	Input Power		X: 100V single phase Y: 200V single phase Z: 200V three phase
Payload *6			MAX. 50kg/unit

1. If the length of the device exceeds 400 cm, the actual belt width will be 7 mm narrower.
2. The maximum speed for the high-speed model is 400.
3. Please check here for details
4. T：コントローラ無しは、N：定速の入力電源Z：200V三相のみ適用します。
5. The high-speed motor output is 90W.
6. For motor output, refer to "Guideline for payload."

• We can also manufacture products other than the standard specifications, so please contact us for details.

Note) Please see here for the frame cross section.

Note: The graph/table below shows the transport mass when the load is distributed horizontally.

Note: If you wish to upgrade the motor output depending on the operating conditions such as speed or the amount of material being conveyed, please select the motor output using the conveying capacity graph above.

• 1. 色文字 は準標準速度を表します。
  2. 定速とインバータ変速の速度は、負荷により±10%程度変動します。
  3. ブラシレス変速時の負荷による速度変動は±1%以内です。